HP ProLiant ML350 G3

Industry Standard
Compliance
ACPI V1.0B Compliant
PCI 2.2 Compliant
PXE Support
WOL Support
PCI-X 1.0 Compliant
Novell Certified
Microsoft® Logo certifications
USB 1.1
Intelligent Manageability Insight Manager 7
HP Systems Insight Manager
Redundant ROM
System Firmware Update
ROMPaq
Remote Insight Lights-Out Edition II (optional)
ProLiant RBSU (ROM-Based Setup Utility)
Automatic Server Recovery-2 (ASR-2)
Drive Parameter Tracking (with Smart Array Controller)
Dynamic Sector Repairing (with Smart Array Controller)
Pre-Failure Warranty (covers processors, memory and hard drives)
Security Power-on password
Setup password
Diskette boot control
Parallel and serial interface control
Disk configuration lock
Power switch security
Server Power Cords Tower models ship standard with country specific, lowline NEMA power cords.
Rack models ship standard with an IEC cable. Rack models for some countries also include a NEMA cord.
Most redundant power supply options ship with country specific power cords with the exception of the IEC
redundant power supply (P/N 283655-B21) which ships with an IEC cable only.
Power Supply 500 Watts, Power Factor Correction (PFC), Hot Plug 100 to 240 VAC Rated Input Voltage (Auto-sensing), CE Mark
Compliant
Optional 2nd power supply for hot-pluggable 1 + 1 redundancy.
System Fans 2 fans ship standard, 2 fans total supported (does not include power supply fans)
Required Cabling For required cabling information, refer to the HP Web site at http://www.hp.com/servers/proliantML350 .
QuickSpecs
HP ProLiant ML350 Generation 3 (G3)
Standard Features
DA - 11430 Worldwide — Version 55 — December 13, 2004 Page 6