OS Support
Microsoft Windows Server 2003
Microsoft Small Business Servers 2003 and 2000
Microsoft Windows 2000 Server and Advanced Server
Microsoft Windows NT® Server 4.0 and Terminal Server 4.0
Novell NetWare
Novell NetWare Small Business Suite
SCO OpenServer
SCO OpenUnix® 8
SCO UnixWare®
IBM OS/2 Warp Server for e-business
LINUX (Red Hat, 2.1 Advanced Server, SuSE, SLES7, UnitedLinux 1.0)
NOTE:
For a more complete and up-to-date listing of supported OSs and versions, please visit our OS Support Matrix
at:
http://www.hp.com/go/supportos
.
NOTE:
Optional hardware may be required to support some operating systems.
NOTE:
For an up-to-date listing of the latest drivers available for the ProLiant ML350, please see:
http://www.compaq.com/support/files/server/us/index.html
.
NOTE:
For a more complete and up-to-date information on Linux support, please visit HP Linux Web site at
http://h18000.www1.hp.com/products/servers/linux/hpLinuxcert.html
.
NOTE:
For information on how to buy server operating systems from HP please visit the OS product site at:
http://h18004.www1.hp.com/products/servers/software/OEM.html
Rack Airflow
Requirements
Rack 10000 series Cabinets
The increasing power of new high-performance processor technology requires increased cooling efficiency for
rack-mounted servers. The 10000 Series Racks provide enhanced airflow for maximum cooling, allowing these
racks to be fully loaded with servers using the latest processors.
CAUTION:
If a third-party rack is used, observe the following additional requirements to ensure adequate airflow and
to prevent damage to the equipment:
Front and rear doors:
If your 42U server rack includes closing front and rear doors, you must allow
830 square inches (5,350 sq cm) of hole evenly distributed from top to bottom to permit adequate
airflow (equivalent to the required 64 percent open area for ventilation).
Side:
The clearance between the installed rack component and the side panels of the rack must be a
minimum of 2.75 inches (7 cm).
CAUTION:
Always use blanking panels to fill all remaining empty front panel U-spaces in the rack. This arrangement
ensures proper airflow. Using a rack without blanking panels results in improper cooling that can lead to thermal
damage.
NOTE:
For additional information, refer to the Setup and Installation Guide or the Documentation CD provided with the
server, or to the server documentation located in the Support section at the following URL:
http://www5.hp.com/servers/proliantml350
.
Installation of Server into
Telco Racks
Support for all 2-post Telco racks requires the use of the rack kit and an additional option kit from Rack Solutions.
http://www.racksolutions.com/hp
.
HP Factory Express
Capabilities
HP Factory Express gives you the flexibility to choose from a full menu of factory capabilities all in one manufacturing
facility, in one process, with one touch giving you full control and access to HP's World class manufacturing facility
anytime. This approach provides you the speed to deploy your IT needs, with total quality assurance, reliability, and
predictability to lower your total cost of ownership by letting HP install, rack, and customize your software and
hardware options for you.
QuickSpecs
HP ProLiant ML350 Generation 3 (G3)
Standard Features
DA - 11430 Worldwide — Version 55 — December 13, 2004
Page 7
To Next Page
Loading...
