Operations 30
Remove the fan modules and the fan blank
1. Power down the server (on page 23).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Unlock the front bezel (on page 24).
4. Place the server on its side.
5. Remove the access panel (on page 25).
6. If installed, remove the PCI air baffle (on page 27).
7. Remove any installed full-length PCI expansion cards ("Remove the full-length expansion board" on
page 29).
8. Remove the system air baffle (on page 28).
9. Remove the fan modules and the fan blank:
a. Disconnect the fan 1 cable from the connector.
b. Remove fan 1.
c. Disconnect the fan 2 cable from the connector.
d. Remove fan 2.
To Next Page
Loading...
