Removal and replacement procedures 49
Cache module for onboard controller (B120i)
To remove the component:
1. Do one of the following:
o For tower models, open and remove the bezel ("Remove the tower bezel" on page 28).
o For rack models, if installed, remove the security bezel (on page 29).
2. Power down the server (on page 27).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
o For tower models, place the server on a flat, level surface with the access panel facing up.
o For rack models, extend the server from the rack (on page 29).
5. Remove the access panel ("Access panel" on page 30).
6. If installed, remove the PCI air baffle ("PCI air baffle" on page 32).
7. Remove any PCI cards installed in PCI slots 3, 4, 5, and 6.
8. Disconnect the capacitor pack cable from the module.
9. Remove the FBWC module from the cache module connector on the system board.
To replace the component, reverse the removal procedure.
FBWC capacitor pack
CAUTION: The cache module connector does not use the industry-standard DDR3 mini-DIMM
pinout. Do not use the controller with cache modules designed for other controller models,
because the controller can malfunction and you can lose data. Also, do not transfer this cache
module to an unsupported controller model, because you can lose data.
To remove the component:
1. Do one of the following:
o For tower models, open and remove the bezel ("Remove the tower bezel" on page 28).
o For rack models, if installed, remove the security bezel (on page 29).
2. Power down the server (on page 27).
To Next Page
Loading...
