Removal and replacement procedures 56
11.
Do one of the following:
o For tower models, install the bezel.
o For rack models, if removed, install the security bezel.
Processor
CAUTION: To avoid damage to the processor:
• Handle the processor only by the edges.
• Do not touch the bottom of the processor, especially the contact area.
IMPORTANT: If installing a processor with a faster speed, update the system ROM before
installing the processor.
To remove the component:
1. Do one of the following:
o For tower models, open and remove the bezel ("Remove the tower bezel" on page 28).
o For rack models, if installed, remove the security bezel (on page 29).
2. Power down the server (on page 27).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
o For tower models, place the server on a flat, level surface with the access panel facing up.
o For rack models, extend the server from the rack (on page 29).
5. Remove the access panel ("Access panel" on page 30).
6. If installed, remove the PCI air baffle ("PCI air baffle" on page 32).
7. Remove the system air baffle ("System air baffle" on page 31).
8. Remove the heatsink.
To Next Page
Loading...
