Hardware options installation 62
2.
Power down the server (on page 22).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
o For tower models, place the server on a flat, level surface with the access panel facing up.
o For rack models, extend the server from the rack (on page 27).
5. Remove the access panel (on page 25).
6. Remove the existing non-hot-plug drive blank.
7. Remove the screws to remove the two metal brackets from the drive blank.
To Next Page
Loading...
