Hardware options installation 74
o
For an ATX power supply
o For a redundant power supply
10. Install the PCI air baffle (on page 29), if removed.
11. Install the access panel (on page 26).
12. Do one of the following:
o For tower models, return the server to an upright position.
o For rack models, install the server onto the rails.
13. Connect each power cord to the server.
14. Connect each power cord to the power source.
15. Press the Power On/Standby button.
The server exits standby mode and applies full power to the system. The system power LED changes
from amber to green.
16. Do one of the following:
To Next Page
Loading...
