Contents 6
Accelerator Error Log ..................................................................................................................... 66
Accelerator Parity Read Errors: X..................................................................................................... 66
Accelerator Parity Write Errors: X .................................................................................................... 67
Accelerator Status: Cache was Automatically Configured During Last Controller Reset............................ 67
Accelerator Status: Data in the Cache was Lost... .............................................................................. 67
Accelerator Status: Dirty Data Detected has Reached Limit... ............................................................... 67
Accelerator Status: Dirty Data Detected... ......................................................................................... 67
Accelerator Status: Excessive ECC Errors Detected in at Least One Cache Line... ................................... 67
Accelerator Status: Excessive ECC Errors Detected in Multiple Cache Lines... ........................................ 67
Accelerator Status: Obsolete Data Detected ......................................................................................68
Accelerator Status: Obsolete Data was Discarded ............................................................................. 68
Accelerator Status: Obsolete Data was Flushed (Written) to Drives....................................................... 68
Accelerator Status: Permanently Disabled ......................................................................................... 68
Accelerator Status: Possible Data Loss in Cache.................................................................................68
Accelerator Status: Temporarily Disabled.......................................................................................... 68
Accelerator Status: Unrecognized Status........................................................................................... 68
Accelerator Status: Valid Data Found at Reset ...................................................................................69
Accelerator Status: Warranty Alert................................................................................................... 69
Adapter/NVRAM ID Mismatch........................................................................................................ 69
Array Accelerator Battery Pack X not Fully Charged........................................................................... 69
Array Accelerator Battery Pack X Below Reference Voltage (Recharging) .............................................. 69
Board in Use by Expand Operation ................................................................................................. 69
Board not Attached........................................................................................................................ 69
Cache Has Been Disabled Because ADG Enabler Dongle is Broken or Missing ..................................... 69
Cache Has Been Disabled; Likely Caused By a Loose Pin on One of the RAM Chips .............................. 70
Configuration Signature is Zero....................................................................................................... 70
Configuration Signature Mismatch................................................................................................... 70
Controller Communication Failure Occurred...................................................................................... 70
Controller Detected. NVRAM Configuration not Present ...................................................................... 70
Controller Firmware Needs Upgrading.............................................................................................70
Controller is Located in Special "Video" Slot ..................................................................................... 70
Controller Is Not Configured........................................................................................................... 70
Controller Reported POST Error. Error Code: X.................................................................................. 71
Controller Restarted with a Signature of Zero .................................................................................... 71
Disable Command Issued ............................................................................................................... 71
Drive (Bay) X Firmware Needs Upgrading ........................................................................................ 71
Drive (Bay) X has Insufficient Capacity for its Configuration................................................................. 71
Drive (Bay) X has Invalid M&P Stamp............................................................................................... 71
Drive (Bay) X Has Loose Cable........................................................................................................ 71
Drive (Bay) X is a Replacement Drive................................................................................................ 72
Drive (Bay) X is a Replacement Drive Marked OK.............................................................................. 72
Drive (Bay) X is Failed.................................................................................................................... 72
Drive (Bay) X is Undergoing Drive Recovery......................................................................................72
Drive (Bay) X Upload Code Not Readable........................................................................................ 72
Drive (Bay) X Was Inadvertently Replaced ........................................................................................72
Drive Monitoring Features Are Unobtainable..................................................................................... 73
Drive Monitoring is NOT Enabled for SCSI Port X Drive ID Y............................................................... 73
Drive Time-Out Occurred on Physical Drive Bay X.............................................................................. 73
Drive X Indicates Position Y............................................................................................................. 73
Duplicate Write Memory Error ........................................................................................................ 73
Error Occurred Reading RIS Copy from SCSI Port X Drive ID............................................................... 73
FYI: Drive (Bay) X is Third-Party Supplied .......................................................................................... 73
Identify Logical Drive Data did not Match with NVRAM...................................................................... 74
Insufficient adapter resources .......................................................................................................... 74
To Next Page
Loading...
Need help?
General
