5. If the computer is on a stand, remove the computer from the stand.
6. Remove the computer access panel.
7. Rotate the power supply all the way back to access the full-height expansion card retention
latch.
NOTE: If you are using a PS/2 mouse and/or PS/2 keyboard, make sure they are unplugged
from the rear of the computer so that the connectors do not block the power supply from rotating
all the way back.
Figure 2-26 Raising the Power Supply
8. Pull back the green tab on the full-height expansion card retention latch to open the latch.
Figure 2-27 Opening the Full-Height Slot Cover Retention Latch
Installing a Full-Height Expansion Card 29
To Next Page
Loading...
