15. If any expansion cards were removed from the old riser card, install the cards into the
appropriate slots on the new riser card. Move the card toward the rear of the chassis so that the
bracket on the card is aligned with the open slot on the rear of the chassis (1). Press the card
straight down into the expansion socket on the riser card (2).
Figure 2-40 Installing an Expansion Card in the Riser Card
16. If an expansion slot cover was removed from the lower slot, replace the slot cover.
Figure 2-41 Replacing the Lower Expansion Slot Cover
Replacing the Riser Card 37
To Next Page
Loading...
