HP SCSI

Embedded NC7761 PCI
10/100/1000T Gigabit
network adapter
Network Interface 10Base-T/100Base-TX/1000Base-TX
Compatibility IEEE 802.3 10Base-T
IEEE 802.3ab 1000Base-T
IEEE 802.3u 100Base-TX
Data Transfer Method 32-bit bus-master PCI
Network Transfer Rate 10Base-T(Half-Duplex) 10 Mb/s
10Base-T(Full-Duplex) 20 Mb/s
100Base-TX(Half-
Duplex)
100 Mb/s
100Base-TX(Full-
Duplex)
200 Mb/s
1000Base-TX (Half and
Full-Duplex)
2000Mb/s
Connector RJ-45
Cable Support 10Base-T Categories 3, 4 or 5 UTP; up to 328 ft (100 m)
10/100/1000Base-TX Category 5 UTP; up to 328 ft (100 m)
Integrated 4 Channel
SATA Controller
(SATA NHP Models
only)
Drives Supported Up to 4 SATA hard drives (1 drive/channel)
Channels 4
Storage Capacity 1 TB
Maximum SATA
Channel Transfer Rate
150 MB/s per channel
SATA Protocols SATA-1a
Internal SATA
Connectors
One 4-lane connector (all four channels)
Single Channel
Ultra320 SCSI Adapter
(SCSI Models only)
Drives Supported Up to 15 SCSI devices Wide
Data Transfer Method 64-bit/100-MHz PCI bus-master
SCSI Channel Transfer
Rate
320 MB/s per channel
Maximum Transfer
Rate per PCI Bus (peak)
1033 MB/s per channel
SCSI Protocols Ultra320, Wide Ultra3, Wide Ultra2, Wide Ultra SCSI-3, Fast-Wide
SCSI-2, and Fast SCSI-2
Fast SCSI-2
Electrical Protocol Low Voltage Differential (LVD)
SCSI Termination Active Termination
External SCSI
Connectors
None.
NOTE: To implement an external SCSI connection, install an optional
controller or internal to external SCSI option kit (part number 159547-
B22 for HD68 or 333370-B21 for VHDCI).
Internal SCSI
Connectors
One 68-Pin Wide Ultra SCSI-3 connectors
QuickSpecs
HP ProLiant ML310 Generation 2
Technical Specifications
DA - 12168 Worldwide QuickSpecs — Version 28 — 3-24-2006 Page 33