4 Fan assembly #21 8/80 SAN Switch
5. Fan assembly #32 Nonport side
3 Fan assembly #1
Figure 32 8/80 and Encryption SAN Switch fan assemblies on the nonport side
CAUTION:
Disassembling any part of the fan assembly voids the part warranty and regulatory certifications.
There are no user-serviceable parts inside the fan assembly. Because the cooling system relies on
pressurized air, do not leave any of the fan assembly slots empty longer than two minutes while the
switch is operating. If a fan assembly fails, leave it in the switch until it can be replaced. Maintain all
three fan assemblies in operational condition to provide redundancy.
Replacing the 8/80 SAN Switch and Encryption SAN Switch fan assembly
Replacing a fan assembly takes approximately two minutes. You will need:
• 8/80 SAN Switch or Encryption SAN Switch
• New fan FRU assembly
• Phillips-head screwdriver #1
Managing the 8-Gb SAN Switches74
To Next Page
Loading...
