Assign is selected as the parameter. The operation uses the following parameters as shown in Table
67.
Table 67 Parameters for R-Cmd.Dev. Operation
DescriptionItem
The remote command device is assigned.Assign
The remote command device is released.Release
Normal end
The operation has ended normally.
Seq.=xxxxxx
Serial number of log information (0000000000 to 4294967295)
Detailed information
Detailed information displays for this operation, as shown in Table 68.
Table 68 R-Cmd.Dev. Operation
DescriptionItem
The LDKC number that the journal group belongs
LDKC
The journal group number
JNLG
The mirror ID
MirrorID
The LDKC, CU , and LDEV numbers of the remote command device
The hyphen (-) displays under the following conditions:
• When assigning a remote command device without specifying a remote
command device as a parameter
• When releasing a remote command device
Cmd.Dev.(LDKC:CU:LDEV)
The result of operation
Normal end: Normal end, Error(xxxx-yyyyy): Abnormal end
xxxx: Part code, yyyyy: Error code
Result
The number of mirrors changedNum. of Mirrors
System-Option Operation
user-name,xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,[Cnt Ac-J],System-Option,,Normal end,,,Seq.=xxxxx
+Max Initial Copy=64
[Cnt Ac-J]
HP XP Continuous Access Journal Software function
System-Option
System-Option operation
XP Continuous Access Journal Software Function112
To Next Page
Loading...
