DescriptionItem
The number of days set in Retention Term.
A hyphen (-) is output when setting is not changed.
RT
The result of operation.
Normal end: Normal end, Error(xxxx-yyyyy): Abnormal end
xxxx: Part code, yyyyy: Error code
Result
The number of the logical volumes where the attribute has been set.Num. of LDEVs
1
When bit 5, 6, and 7 are all 0 (zero), Read/Write has been set.
Expiration-Lock Operation
user-name,xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,[Data Ret],Expiration-Lock,SLPR#xx:Enable,Normal end,,,Seq.=xxxxx
[Data Ret]
Data Retention Utility function
Expiration-Lock
Expiration-Lock operation
SLPR#xx:Enable
SLPR#xx: Enable is selected as the parameter. The operation uses the following parameters, as shown
in Table 73.
Table 73 Parameters for Expiration-Lock Operation
DescriptionParameter
The expiration-lock setting is enabled for SLPR number xx.SLPR#xx:Enable
The expiration-lock setting is disabled for SLPR number xx.SLPR#xx:Disable
The expiration-lock setting is enabled in the storage system.SYSTEM:Enable
The expiration-lock setting is disabled in the storage system.SYSTEM:Disable
Normal end
The operation has ended normally.
Seq.=xxxxxx
Sequence number of log information (0000000000 to 4294967295)
Data Retention Utility Function118
To Next Page
Loading...
