HP StorageWorks XP20000/XP24000 - Disk Array - Page 277

36 SNMP Function
Set SNMP Agent Operation
user-name,xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,[SNMP],Set SNMP Agent,,Normal end,,,Seq.=xxxxx
+Install=Disable
+Manager=[(158.214.133.1),(158.214.133.2),(158.214.133.3),(1:0:0:0:0:0:0:1),
(snip)
-(158.214.133.31),(158.214.133.32),(AAAA:0:0:0:0:0:0:FFFF)],Num. of Managers=xx
+Community=1234567891123456789212345678931234567894123456789512345678961234567897123
45678981234567899123456789012345678911234567892123456789312345678941234567895
++Trap=[(158.214.133.1),(158.214.133.2),(158.214.133.3),(1:0:0:0:0:0:0:1),
(snip),
-(158.214.133.31),(158.214.133.32),(AAAA:0:0:0:0:0:0:FFFF)],Num of Traps=xx,
(snip)
-Num. of Communities=xx
+System Group(Name,Contact,Location)=
{12345678911234567892123456789312345678941234567895123456789612345678971234567898123
456789912345678901234567891123456789212345678,
-12345678911234567892123456789312345678941234567895123456789612345678971234567898123
456789
9123456789012345678911234567892123456789312345678941234567895123456789612345,
-12345678911234567892123456789312345678941234567895123456789612345678971234567898123
456789
9123456789012345678911234567892123456789312345678941234567895123456789612345}
[SNMP]
Simple Network Management Protocol function
Set SNMP Agent
Set SNMP Agent operation
Normal end
The operation has ended normally.
Seq.=xxxxxx
Sequence number of log information (0000000000 to 4294967295)
Detailed Information
Detailed information displays for this operation, as shown in Table 251.
Table 251 Set SNMP Agent Operation
DescriptionItem
The setting status of SNMP Agent.
Enable, Disable
Install
The IP address of the registered SNMP manager. The IP address divided by a period (.)
is an IPv4 address, and the IP address divided by a colon (:) is an IPv6 address.
Manager
The number of the registered SNMP managers.Num. of Managers
XP24000/XP20000 Audit Log User and Reference Guide 277