Volume Initialize Operation
user-name,xx,YYYY/MM/DD,HH:MM:SS.xxx,00:00,[VLL],Volume Initialize,,Normal end,,,Seq.=xxxxxx
+{PG,LDKC:CU:LDEV}=[{XX-XX-(X),0xXX:0xXX:0xXX},{XX-XX-(X),0xXX:0xXX:0xXX}],Num. of PGs=2
[VLL]
Virtual LVI / Virtual LUN function
Volume Initialize
Volume Initialize operation
No parameter
No parameter is selected in the above example. This operation uses the following parameters, as
shown in Table 286.
Table 286 Parameters for Volume Initialize Operation
DescriptionParameter
Unformatted Volume Initialize. The logged information indicates that the volume was
created.
Non Format
Quick Formatted Volume Initialize. The logged information indicates that the formatting
was only requested, but not finished.
Quick Format
NOTE:
No parameters are selected for any case other than those described in this table. The logged information
indicates that the formatting was only requested, but not finished.
Normal end
The operation has ended normally.
Seq.=xxxxxx
Sequence number of log information (0000000000 to 4294967295)
Detailed Information
Detailed information displays for this operation, as shown in Table 287.
Table 287 Volume Initialize Operation
DescriptionItem
The parity group numbers
The parity group number whose first letter is E indicates that an external volume is present
in the parity group.
PG
The LDKC, CU, and LDEV numbers
None is output when the LDKC, CU, and LDEV numbers are not specified
LDKC:CU:LDEV
The number of parity groupsNum. of PGs
XP24000/XP20000 Audit Log User and Reference Guide 311
To Next Page
