HP T1000 G3 User Manual

Grounding methods to prevent electrostatic discharge
Several methods are used for grounding. Use one or more of the following methods when handling or installing electrostatic-sensitive parts:
S Use a wrist strap connected by a ground cord to a grounded workstation or computer chassis. Wrist straps are flexible straps with a
minimum of 1 megohm +10 percent resistance in the ground cords. To provide proper ground, wear the strap snug against the skin.
S Use heel straps, toe straps, or boot straps at standing workstations. Wear the straps on both feet when standing on conductive floors or
dissipating floor mats.
S Use conductive field service tools.
S Use a portable field service kit with a folding static-dissipating work mat.
If you do not have any of the suggested equipment for proper grounding, have an authorized reseller install the part.
For more information on static electricity or assistance with product installation, contact an authorized reseller.

HP T1000 G3 Specifications

General

Topology	Line Interactive
Input Voltage	120V
Output Voltage	120V
Interface	USB
Form Factor	Tower
Output Connections	6 x NEMA 5-15R
Input Connection	NEMA 5-15P
Typical Backup Time at Half Load	10 minutes
Typical Backup Time at Full Load	3 minutes
Efficiency at Full Load	95%
Typical Recharge Time	8 hours
Efficiency	95%
Operating Temperature	0°C to 40°C
Storage Temperature	-15°C to 45°C
Humidity	0-95% non-condensing
Capacity	1000 VA
Battery Type	Sealed Lead Acid
Frequency	50/60Hz
Transfer Time	4-8 ms
Warranty	3-year limited warranty