Need help?Do you have a question about the HP T750 and is the answer not in the manual?
General| Output Voltage | 230V |
|---|---|
| Input Voltage | 230V |
| Interface Port | USB |
| Waveform Type | Stepped approximation to a sinewave |
| Nominal output voltage | 230V |
| Nominal input voltage | 230V |
| Battery Type | Sealed lead-acid (VRLA) |
| Topology | Line Interactive |
| Input frequency | 50/60 Hz |
| Output Connections | IEC 320 C13 |
| Input connection type | IEC 320 C14 |
| Typical recharge time | 8 hours |
| Audible alarm | Yes |
| Operating Temperature | 0 - 40 °C |
| Approvals | CE |
| Frequency | 50/60 Hz |
| Control panel | LED status indicators |
| Operating Relative Humidity | 5% to 95% non-condensing |
Details the components and layout of the UPS front panel.
Describes the buttons and LED indicators on the UPS front panel for status monitoring.
Illustrates and labels the rear panel components of the NA/JPN model UPS.
Illustrates and labels the rear panel components of the INTL model UPS.
Essential safety instructions to follow during installation, operation, and maintenance.
Specifies the environmental and electrical conditions required for safe installation.
Guidance on verifying the battery's recharge date before using the UPS.
Step-by-step instructions for safely connecting the UPS batteries.
How to set the UPS to the correct input voltage using DIP switches.
Instructions for connecting the UPS to a host computer for management.
Details on establishing a serial connection between the UPS and a computer.
Instructions for establishing a USB connection between the UPS and a computer.
Guidance on using network transient protectors for surge protection.
Steps for safely connecting the UPS to the main power source.
How to connect peripheral devices to the UPS output receptacles.
Information on the required battery charging time before operation.
Procedure for turning on and starting the UPS unit.
How to perform a UPS self-test to check battery and load capacity.
Procedure to mute or silence audible alarms on the UPS.
Details on different alarm types, their causes, and if they can be silenced.
Step-by-step guide to safely shut down the UPS and connected devices.
Overview of the features and capabilities of the HP Power Manager software.
Instructions for updating the UPS firmware using a computer connection.
Safety procedures for cleaning up battery acid spills.
Steps to diagnose and resolve issues where the UPS fails to start.
Guidance on identifying and resolving audible alarm conditions.
Troubleshooting steps when the UPS runs continuously on battery power.
Diagnosing frequent switching between utility and battery power.
Troubleshooting low or unexpected battery backup runtime.
Explanation for the slight clicking noise from the UPS.
Interpreting and responding to flashing Power LED status.
Understanding the meaning of a green Voltage Configuration LED.
Troubleshooting overloads indicated by the Output Load Level LED.
Resolving issues when the Battery Charge LED indicates a problem.
Addressing the amber Battery Warning LED status.
Troubleshooting site wiring faults indicated by the LED.
Details the physical dimensions and weight of the UPS unit.
Provides information on the UPS's input voltage and frequency requirements.
Lists the UPS output receptacles and maximum current ratings.
Details the VA rating, power rating, and voltage settings for power protection.
Specifies the available nominal output voltages for different configuration settings.
Defines the voltage regulation for utility power and battery power.
Details features like efficiency, wave shape, and surge suppression.
Information on battery type, voltage, and charging characteristics.
Estimated battery runtime based on load percentage and watts.
Details operating and non-operating temperature, humidity, and altitude limits.
Information on how to order replacement parts for the UPS.
A list of available spare parts and their corresponding part numbers.
Information on supported hardware options for the UPS.
Information to have ready before contacting HP technical support.
Contact details for HP technical support and service centers.
Details the 3-year limited warranty coverage for the UPS.
Information on the Computer Load Protection Guarantee offered.
Explains the warranty covering battery replacement before failure.
Explains the purpose and location of regulatory model numbers.
FCC rules and regulations concerning RF emission limits.
How to interpret the FCC classification label on the device.
Compliance information for Class A digital devices under FCC rules.
Compliance information for Class B digital devices under FCC rules.
FCC declaration details and contact information for US products.
FCC notification regarding unauthorized device modifications.
Requirements for using shielded cables for FCC compliance.
Canadian regulatory compliance for Class A and B equipment.
EU directives and conformity marking for the product.
Japanese regulatory compliance information, including VCCI markings.
BSMI warning for Class A equipment regarding potential RF interference.
Korean regulatory compliance for Class A and B equipment.
Safety warnings and disposal guidelines for battery replacement.
Specific instructions regarding the use of the provided power cord in Japan.
Precautions to avoid damaging the system from static electricity discharge.
Methods and tools for proper grounding to prevent static discharge.
To Next Page
