To Next PageTo Next PageWhat to do if my HP R/T3000 G4 LV NA/JP UPS battery life ends?
If your HP UPS indicates the end of battery life, this means the battery has reached its end. Contact your service representative for battery replacement.
What to do if my HP R/T3000 G4 LV NA/JP UPS is overloaded?
If your HP UPS is overloaded, it means the power requirements exceed the UPS capacity (greater than 105% of nominal). To resolve this, remove some of the equipment from the UPS. The UPS will continue to operate but may shut down if the load increases further. The alarm will reset when the overload condition is no longer present.
Why does my HP R/T3000 G4 LV NA/JP show a fault?
If your HP UPS shows a fault, it indicates that the UPS has an internal fault and is not protecting the equipment. Record the alarm message and the UPS Serial Number, then contact your service representative.
How to fix HP R/T3000 G4 LV NA/JP UPS when batteries are disconnected?
If your HP UPS indicates that the batteries are disconnected, it could be due to the UPS not recognizing the internal batteries, or the batteries being physically disconnected. Verify that all batteries are properly connected. If the condition persists, contact your service representative.
General| Waveform Type | Sine Wave |
|---|---|
| Input Frequency | 50/60 Hz |
| Output Frequency | 50/60 Hz |
| Topology | Double Conversion Online |
| Number of Output Connectors | 8 |
| Emergency Power Off (EPO) | Yes |
| Audible Alarm | Yes |
| Power Capacity | 2700 W |
| Output Voltage | 100 V, 120 V |
| Interface | USB |
| Nominal Input Voltage | 100 V, 120 V |
| Typical Recharge Time | 3 hours |
| Data Line Protection | RJ-45 |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -15°C to 45°C |
| Humidity | 0% to 95% (non-condensing) |
General safety guidelines, environmental conditions, symbols, and warnings.
Guidelines for qualified personnel, grounding, and safe battery handling.
Requirements for installation, placement, ventilation, and storage.
Description of the control panel layout, buttons, and status indicators.
Details on LCD information, status icons, and their meanings.
Procedures for starting, operating, and shutting down the UPS.
Instructions for initiating UPS operation from battery power.
Guidance for resolving common UPS problems like battery, overload, and faults.
Critical safety precautions before servicing UPS batteries.
Step-by-step guide for removing the UPS battery module.
Procedure for installing a new UPS battery module.
