What to do if my HP T1500 G4 NA/JP UPS is overloaded?
If your HP UPS is overloaded, it means the power requirement exceeds the UPS capacity (greater than 105% of nominal). To resolve this, remove some of the equipment from the UPS. The UPS will continue to operate, but might shut down if the load increases. The alarm will reset when the condition becomes inactive.
Why does my HP T1500 G4 NA/JP have a battery fault?
A battery fault in your HP UPS can occur for a couple of reasons: * The batteries in the UPS might be disconnected. Verify that all batteries are properly connected. If the error persists, note the alarm message and the UPS serial number, and then contact your service representative. * The end of battery life might be reached. If this is the case, contact your service representative for battery replacement.
What to do if my HP T1500 G4 NA/JP UPS has a short-circuit fault?
If your HP UPS indicates a short-circuit fault, it means a short-circuit has occurred. Check the device connection or integrity. If the error persists, note the alarm message and the UPS serial number, and then contact your service representative.
How to fix a fan fault on my HP T1500 G4 NA/JP UPS?
If your HP UPS is showing a fan fault, check that no object is blocking the fan. If the error persists, note the alarm message and the UPS serial number, and then contact your service representative.
What does it mean if my HP T1500 G4 NA/JP has a charger fault?
If your HP UPS has a charger fault, it means the UPS is no longer charging the battery. Note the alarm message and the UPS serial number, and then contact your service representative.
Step-by-step guide to starting the UPS and ensuring normal operation.
Details how the UPS operates when AC power is lost, including low-battery warnings.
Specific warnings regarding fire or chemical burns when handling battery modules.
Step-by-step instructions for the physical removal of the battery module from the UPS.
General| Nominal output voltage | 100V, 120V |
|---|---|
| Nominal input voltage | 100V, 120V |
| Input connection type | NEMA 5-15P |
| Typical recharge time | 3 hour(s) |
| Interface Port | USB |
| Capacity | 1500 VA |
| Frequency | 50/60 Hz +/- 3 Hz auto-sensing |
| Waveform | Stepped approximation to a sinewave |
| Operating Temperature | 0 - 40 °C |
| Storage Temperature | -15 - 45 °C |
| Output power capacity | 1500 VA / 1000 W |
| Output Connections | NEMA 5-15R |
| Control panel | LED status display |
| Audible alarm | Alarm when on battery |
| Battery Type | Maintenance-free sealed Lead-Acid battery with suspended electrolyte |
| Relative Humidity | 0 - 95% (Non-condensing) |
| Safety Approvals | FCC Part 15 Class B |
To Next Page
