3. Installation
3.7 Ground connection
HP R/T3000 G4 HV NA/JP and R/T3000 G4 INTL UPS
Check that the indications on the name plate located on the back of the UPS correspond to the AC-power source and the
true electrical consumption of the total load.
10
32 35
9
7
31
8
The UPS charges the battery as soon as it is connected to the AC power source, even if the button
is not pressed.
After the UPS is connected to the AC power source, eight hours of charging is required before the battery can
supply the rated backup time.
1. Connect the
supplied cable
31
(250V -
16A) to the socke
10
, then
to the AC-power source.
2. Connect the loads to the UPS using the
cables
32
.
It is preferable to connect the
priority loads to the four outlets marked
9
and the non-priority loads to the four outlets
marked
8
that can be programmed in pairs
(1 and 2).
For the R/T3000 G4 HV NA/JP HV and R/T3000
G4 INTL models, connect any high-power
devices to the 16A outlet
7
.
3. To program shutdown of outlets
8
during
operation on battery power and thus opti-
mise the available backup time,
please check the in/out settings.
4. Fit the connection securing system
35
that
prevents the plugs from being pulled out acci-
dentally.
9
To Next Page
Loading...
