16
Complete the Questionnaire to Check Your Understanding
Complete the Questionnaire to Check Your Understanding
Draw a circle around each letter that corresponds with a correct answer.
(There may be more than one correct answer to each question).
1 Can you use a non-Ultra ATA cable with an Ultra ATA device?
a Yes, you can use a non-Ultra ATA cable with an Ultra ATA device.
b No, you must use an Ultra ATA cable with an Ultra ATA device.
2 During the flashing of the BIOS, there is a power failure. How can the
system be recovered?
a Restart the PC and try flashing the BIOS again.
b Use the Crisis Recovery process to restore the contents of the
corrupted EEPROM.
c Toggle switch 9 to the OPEN position and restart the PC.
3 After changing the order of the IDE hard disk drive on the IDE cable,
nothing is changed in the Boot/Hard disk drive list. Can you explain why?
a The configuration data stored in the EEPROM is corrupt.
b The IDE cable is not connected correctly to the disk drives.
c The boot order is not determined by the physical location of the IDE
hard disk on the IDE cable.
4 What must be verified before you change the system board?
a Verify that the latest driver versions are installed.
b Check that the latest BIOS has been flashed.
c Ensure that the problem isn’t described in the product bug-list.
d You are electrostatically grounded.
1book.bk : 1ch01.fb4 Page 16 Monday, January 19, 1998 5:12 PM
To Next Page
Loading...
