HP xw9400 - Chapter 2 Getting Started; Workflow for Hardware Setup and Application Installation

Getting Started
Topics in this chapter:
■
Workflow for Hardware Setup and Application Installation on page 5
■
Hardware Configuration Guidelines on page 6
■
BIOS and Firmware on page 10
Workflow for Hardware Setup and Application
Installation
The following procedure provides the general workflow for installing an Autodesk
Visual Effects and Finishing application on a workstation.
To install a Visual Effects and Finishing application on a workstation:
1 Review the guidelines for working with hardware components. See Hardware
Configuration Guidelines on page 6.
2 Connect all peripherals (mouse, keyboard, Wacom
®
tablet, graphics
monitor) to the proper ports, and connect your workstation to the Autodesk
Wire
®
network. See Peripherals Connection Diagrams on page 19.
3 Connect your workstation to the storage. See Connecting Storage on page
24.
2
5