2 In the Miscellany menu, select Defaults: RESET.
All settings are reset to their factory defaults.
NOTE The factory default for the items in the AES setup menu is SRC ON.
Both local and remote control require these items to be set to SRC OFF. If
you reset to defaults, be sure to manually set these items back to OFF (you
cannot adjust these settings remotely).
Lucid ADA 88192 Converter Settings for Remote
Control
You must configure the following settings to control the converter remotely.
Any setting not listed here either has no effect with the application or can be
set through the audio preferences of the application.
CommentMenu ItemMenu
ADAT INs: SRC ONADAT
INs: SMUX OFF
ADAT
AES IN1+2: SRC OFFAES
IN3+4: SRC OFFAES
AES
IN5+6: SRC OFFAES
IN7+8: SRC OFF
IN1+2: SoftClip
OFFIN3+4: SoftClip
AnalogAnalog INs:
SoftClip
OFFIN5+6: SoftClip
OFFIN7+8: SoftClip OFF
3 is the recommended settingClip Detect: 3Meter
8 is the recommended settingRoute Unit: 8SystemMiscellany
44 | Chapter 5 Setting Up Audio Hardware
To Next Page
Loading...
