Setting Up Video
Hardware
Topics in this chapter:
■
Video I/O Setup on page 27
■
Standard VTR Control Cable Pinout on page 34
■
Setting Up VTR Emulation on page 34
Video I/O Setup
Use the information and wiring diagrams in this section to connect the video
I/O components and a broadcast monitor to the HP xw9400 workstation.
Depending on the video preview device the workstation is equipped with, and
on whether the Real-Time Deliverables (RTD) feature will be used or not, there
are three possible video I/O configurations for your workstation:
■ For workstations equipped with a Miranda DVI-Ramp2 as a video preview
device, see Video I/O Setup for Workstations Using a DVI-Ramp2 on page
28.
■ For workstations equipped with a NVIDIA Quadro SDI board as a video
preview device, without support for Real-Time Deliverables, see the first
4
27
To Next Page
Loading...
