HP Z200 - Small Form Factor Workstation Setup And Configuration Guide

22
ii. User opt-in.
Default Setting : User Consent is required for KVM session
Recommended Setting : User Dependent
iii. Opt-in Configuration from remote IT
Default Setting : Enabled Remote Control of KVM Opt-in Policy
Recommended Setting : User Dependent
Disable Remote Control of KVM Opt-in Policy – This option disables the Remote
User’s ability to select User OPT-IN Policy. In this case only the local user can
control the opt-in policy.
Enable Remote Control of KVM Opt-in Policy - Enables Remote User’s ability to
select User OPT-IN Policy.
Note: Intel integrated graphics CPU (iGfx) CPU is required for KVM option and
console support at this time may be limited.
15. Exit MEBx Menu.
Select the Previous Menu option to get back MEBx Main Menu and select Exit to exit
the MEBx Setup and save settings. The system will reboot.
Once the system reboots, it will go from In-Setup phase to Operational phase. AMT is
fully operational. Once in the Operational phase, the system can be remotely
managed through the Intel AMT WebGUI or ISV remote console and can be provided
to the end-user for regular use.

HP Z200 - Small Form Factor Workstation Specifications

General

Brand	HP
Model	Z200 - Small Form Factor Workstation
Category	Desktop
Language	English