HP Z200 - Small Form Factor Workstation Setup And Configuration Guide

35
d. IDE Redirection
Default Setting : Enabled
Recommended Setting : Enabled
Select Enabled.
e. Legacy Redirection Mode.
Default Setting : Disabled
Recommended Setting : Disabled
Select Disabled.
This option allows the Redirection feature to work with the pre-AMT 6.0
remote consoles (need to set to Enabled).
20) Check KVM Configuration.
a. KVM feature Selection.
Default Setting : Enabled
Recommended Setting : Enabled
b. User opt-in.
Default Setting : User Consent is required for KVM session
Recommended Setting : User Dependent
c. Opt-in Configuration from remote IT
Default Setting : Enabled Remote Control of KVM Opt-in Policy
Recommended Setting : User Dependent
Disable Remote Control of KVM Opt-in Policy – This option disables the
Remote User’s ability to select User OPT-IN Policy. In this case only the
local user can control the opt-in policy.
Enable Remote Control of KVM Opt-in Policy - Enables Remote User’s
ability to select User OPT-IN Policy
21) Return to MEBx Main menu. And select Exit.
Select Y.
This will exit the MEBx Setup and save settings.
22) The system will display an Intel ME Configuration Complete message (only
once).
23) System will reboot.
24) Turn off system and remove power.
At this point the system is out of Factory Mode and is in In-Setup mode. It is
ready to be deployed in a corporation.
25) User plugs system into a power source and connects the network.
Only use the integrated Intel NIC. Intel AMT does not work with any other NIC
solution.

HP Z200 - Small Form Factor Workstation Specifications

General

Brand	HP
Model	Z200 - Small Form Factor Workstation
Category	Desktop
Language	English