46
Appendix A: Frequently Asked Questions
Q: How can the MEBx be locally accessed?
A: The MEBx can be locally accessed by pressing CTRL-P during POST.
Q: Why is the CTRL-P prompt not displayed during POST?
A: By default the CTRL-P prompt is hidden during POST, but it can be display if set
in F10 Setup.
Q: What is the default username and password for the MEBx?
A: The default username and password are both “admin”.
Q: Why does the MEBx not accept my new password?
A: All MEBx passwords, other than the default password, must comply with the
strong password guidelines. See the Password Guidelines section for more
details.
Q: If the password is not known, how can the system be recovered?
A: Clearing CMOS will reset all MEBx options including the password. The
password will revert back to the default password of “admin”.
Q: How can all MEBx options be restored to the factory defaults?
A: See Full Return to Factory Defaults section.
Q: What happens if the wrong password is entered incorrectly multiple times?
A: Once the password is entered incorrectly three times, the system will reboot.
The user can go back into the MEBx after the reboot and attempt to enter the
password again.
Q: Can the WebGUI be used locally to access the MEBx on the system it is
running from?
A: No. This is because WebGUI access has to come from an outside network to
a specific IP and port. Local access does not originate from an outside
network.
Q: Why does a new password set with the WebGUI cannot be used locally in the
MEBx?
A: A password set with the WebGUI is a remote password and will only work
when accessing the MEBx remotely. It does not work with the MEBx locally.
The local password must be used to locally access the MEBx.
Q: Is TLS required?
A: No. TLS is optional.
Q: If TLS is not used, then what is used?
A: HTTP Digest will be used for mutual authentication if TLS is not used.
Q: Who provides Setup and Configuration Servers?
To Next Page
Loading...
