5
English
Message or code Recommendation
61:01 The le format is wrong and the printer cannot process the job. Check the graphic
language setting of your printer. If you are sending PostScript from Mac OS over a
USB connection, select ASCII encoding in both the driver and the application. Check
for the latest rmware and driver releases.
62, 63, 64, 65, 67 Update your printer’s rmware.
63:01 The printer has failed to get an IP address. Connect to another network or change
the IPv4 con guration.
71.04 Out of memory. To avoid this, in the HP-GL/2 and HP RTL driver select the
Advanced tab and then Send job as a bitmap.
74:04 The rmware upgrade has failed. Press OK and try again.
74.1 Try the rmware update again. Do not try to use your computer while the update
is in progress.
74.8:04 The rmware upgrade has failed. Your rmware le may be incorrect; try to
download it again.
79:03 Restart the printer.
79:04 Update your printer’s rmware.
81:01, 86:01 Follow the instructions on the front panel. You may be asked to run a test
procedure and write down a numeric code before contacting your support
representative.
94, 94.1 Restart color calibration.
Power speci cations
Maximum power 120 W
Frequency 50/60 Hz
Input voltage ~100–240 V
Maximum current 2 A
Enfocus Software - Customer Support
To Next Page