Press the OK key on the front panel when
you have removed all of the setup print-
heads. The front panel then prompts you to
install the new printheads.
Shake each new printhead before
unwrapping it. This will reduce the time
the printer takes to check the printheads
later.
After shaking, unwrap each printhead. Remove all orange parts.
67 68 69 70
Pull the blue handle towards you as far
as it will go, picking up the latch in the
process.
73
Insert the printheads one by one. Each
printhead is marked with its own colors,
and should be inserted only into the
correct slot marked with the same colors.
Insert the printheads with the blue handle
towards you.
71
Push each printhead into the slot until it
clicks into place. The front panel tells you
whether the printhead has been inserted
correctly.
72
Push the handle down on top of the
printhead cover.
The printer checks and prepares the new
printheads, which may take 30 to 40
minutes depending on the condition of the
printheads and of the environment.
Close the window.
74
To Next Page
Loading...