The cartridges must be inserted the right
way around: the ink outlet in the cartridge
should meet the ink inlet in the slot. Push
the cartridge into the slot until it clicks
into place. The printer beeps whenever a
cartridge is successfully inserted.
Open the window and grasp the blue
handle of the printhead cover.
59 60
61
62
When you have inserted the correct
cartridges into the right-hand side of the
printer, open the cover on the left-hand
side and insert the other cartridges there.
Install the printheads
When you have inserted all of the ink
cartridges correctly, the printer must pre-
pare the ink system for its first use. It will
do this immediately if you press the OK
key, or after a 60-second pause if you do
not press the OK key. When the ink system
is ready, the front panel will prompt you to
open the window.
The front panel prompts you to remove the
setup printheads and press the OK key
when you have finished.
65
Pull the blue handle towards you as far as
it will go.
63
Lift the handle up to open the printhead
cover.
The front panel prompts you for the next
step: removing the printheads. Do not
press OK until you have removed all the
printheads.
64
Remove and discard all orange setup
printheads.You may need to use force to
extract each printhead.
The setup printheads contain ink, which
could leak out. Avoid touching pins, leads
or circuits.
66
To Next Page
Loading...