a. Remove the screw (1) that secures the right side of the display hinge cover. Lift the display
hinge cover up using a pry tool (2), and remove it (3).
b. Remove the three Phillips broadhead M2.0 × 2.0 screws (1) from each hinge.
c. Remove the hinges from the display (2).
The display hinges and hinge cover are available as spare part number N94021-001 or models with
WWAN and P00636-001 for models without WWAN.
8. To remove the display/camera cable, peel the cable off the inside of the display back cover (1),
remove the cable from the clips at the bottom of the display back cover (2), and then remove the
cable (3).
Display panel cables are available in the display cable kit, as the spare part number of N98639-001.
Display assembly
69
To Next Page
Loading...
