LPQ58/80 User Manual
Rev 1.0 www.hprt.com
1. Please follow the following steps to enter parameters setting mode:
NOTE:The two actions should be done in the 2 seconds after printer power on.
a. Press 【POWER】 button three times
b. Press 【FEED】 button one time
2. When printer succeeds in entering the parameters setting mode, it prints the following contents
and enters the first parameter setting – baud rate setting.
Enter setting mode:
Setting baud:
Baud = 9600
It prints current baud rate 9600 and please press 【 POWER 】 button to select the baud rate
required. Press 【POWER】 button one time, the printer prints the current ‘ baud= ***** ’.When
the printer prints the baud rate required, press the 【FEED】 button to confirm and quit, then enter
the second setting – paper type setting.
Optional baud rates: 9600, 19200, 38400,57600, 115200.
3. After entering paper type setting mode, it prints the following contents:
setting paper type：
Paper type: Label
If user wants to change the paper type, press【POWER】button to select. Press【POWER】button
one time, and the printer prints the current paper type: ***** When the printer shows the paper
type required, press 【FEED】button to confirm and quit The printer enters the third setting – print
density setting.
Optional paper type: receipt, label ,black mark and auto
Note:
Default media/paper type is label. Under auto mode, printer feeds paper automatically to
identify the media type after power on. Max label gap is 8mm. The default label height is
120mm. Max label height which can be located by printer is 500mm. It can be modified
according
to
the
user
’
s
need
by
printer
utility
tool.See
more
information
in
<<P
rinter
Ut
ility
T
ool
In parameter setting mode,【POWER】 button is used for choosing the option and
【FEED】 button is used for confirmation and quit the current menu to enter the next
menu.
To Next Page
Loading...
Need help?
General
