SL42 User Manual
3.6.3 Quick Calibration
Users must carry out the calibration under the conditions below:
￭The first time to use the printer since installation.
￭The first time to use the printer since sensor cleaning.
￭Reuse the printer when it has not been used for a long time.
￭Change a new type of media.
￭Printer cannot recognize the mark.
￭Huge change of the operating environment.
Calibration method:
1. Carry out the calibration manually.
When the printer is ready, keep press the feed button until the status indicator (blue) flash 2
times, then release the feed button, the printer began to calibration. When the printer learns in
continuous paper mode, it is invalid.
2. Manual positioning learning after cover closing:
Users can also complete their calibration through the printer tool software, as detailed in the
"chapter 6th Label Printer Utility Instructions" section.
Note:
After the quick calibration, users could open the printer cover to pull back the learned
paper in avoid of paper wasting.
To Next Page
Loading...
Need help?
General
