incoming calls.
If you still wish to set it up, after setting the year's last digit in step 4, press SET again to
change the Month (MM), use dial-pad to input the correct month, then press SET again to
change the Day (DD), use dial-pad to input the correct month, then press SET again to change
the HOUR (HH), use dial-pad to input the correct month, and then press SET again to change
the Minutes (MM). Then, hang up the handset and wait 15 seconds to exit programming
mode.
2.0 Setting the LCD Display Brightness Levels
The factory default settings for the display brightness is 2. To adjust it, follow the steps below:
Step 1. Press SET button (LCD displays Set 1234567)
Step 2. Lift off the handset and press 2 using the dial-pad. (LCD displays "LCD 2")
Step 3. Press UP or DOWN buttons (◄ or ►) to change the LCD levels from 2 to 1,2,3,4
Step 4. When done, hang up handset and wait 15 seconds to exit programming mode.
3.0 Adding Outgoing (dialing) Blocked Numbers to the BLACKLIST
Please follow the steps below to manually add phone numbers (also prefixes or area codes)
that you wish to block dialing from your phone line.
IMPORTANT: Make sure your T-Lock Call Blocker is installed in series with your existing
phone(s) in order for the T-Lock Call Blocker to block all the outgoing numbers calls.
Step 1. Press SET button (LCD displays Set 1234567)
Step 2. Lift off the handset
(1)
and press 3 (LCD displays a blinking cursor "_" indicating input
mode).
Step 3. Input the phone number
(2)
(or area code or prefix) you wish to block.
Step 4. Press UP or DOWN buttons (◄ or ►) to save
(4)
(LCD displays "SUCCEED").
Repeat steps 3-4 to continue inputting number(s) you wish to block.
Step 5. When done, hang up handset and wait 15 seconds to exit programming mode.
3.1 Browsing / Removing Outgoing (dialing out) Blocked numbers from the BLACKLIST
To remove a number from the blocked list
(3)
, you need to press SET, press 3, use the UP &
DOWN buttons (◄ or ►) to browse the list of blocked numbers you wish to remove, and then
press the REMOVE button to remove the number displayed (LCD
(3)
displays "DEL" and
"SUCCESS").
4.0 Renumbered as 5.0
To Next Page
Loading...
Need help?
General