5.0 Adding Phone Numbers to the BLACKLIST e.g. Blocking Unwanted Phone Numbers
There are 3 ways of adding unwanted phone numbers to the BLACKLIST:
(1) When an unwanted call is ringing, simply press the BLACKLIST button before answering it
to disconnect the call and add the number to the BLACKLIST.
(2) After receiving an unwanted call ... At a later time, you can use the scroll UP/DOWN
buttons (◄ or ►) to browse the list of recent incoming calls (see 8.1), then press the
BLACKLIST button to add the unwanted phone number to BLACKLIST (LCD displays "SAVE" and
"SUCCEED").
(3) You may also add numbers manually. Please follow the instructions below to add incoming
phone numbers to the BLACKLIST.
Step 1. Press SET button (LCD displays Set 1234567)
Step 2. Lift off the handset and press 4 (LCD displays the first number stored in the BLACKLIST.
If empty, a blinking cursor should be shown as "_" indicating input mode).
Step 3. Input phone number
(2)
to be added to the incoming BLACKLIST
Step 4. Press UP or DOWN buttons (◄ or ►) to save
(4)
(LCD displays "SUCCEED").
Repeat steps 2-4 to add up to 1,200 numbers (up to 16 digits in length, each)
Step 5. When done, hang up handset and wait 15 seconds to exit programming mode.
TIP: The recommended way to build your BLACKLIST is to use options 1 or 2 above. If you
choose option (3) above, you may need to add area code + number and also 1 + area code +
number (this depends on how the leading 1 is handled by your phone service provider).
5.1 Adding Incoming Area Codes or Prefixes to the BLACKLIST
Follow the steps below to add incoming phone area codes and prefixes to BLACKLIST.
Step 1. Press SET button (LCD displays Set 1234567)
Step 2. Lift off handset and press 5 (If your BLACKLIST is empty, a blinking cursor should be
shown as "_" indicating input mode. Otherwise, the LCD will display the first stored number in
the BLACKLIST)
Step 3. Input the area code or prefix you wish to block
(2)
(example area code: 305, prefix 305-
558) using the dial-pad on your telephone handset.
Step 4. Press UP or DOWN buttons (◄ or ►) to save number
(4)
(LCD
displays "SAVE" and
"SUCCEED"). Repeat steps 2 & 3 to add up to 10 sets (up to 10 digits in length, each)
Step 5. When done, hang up handset and wait 15 seconds to exit programming mode.
6.0 Turn ON/OFF feature to Block all Incoming Calls with no Caller ID Info
This feature is disabled (OFF) as a factory default setting. Please follow the steps below if you
To Next Page
Loading...
Need help?
General