14 SECURIO B 22 12/2014
english
6 Troubleshooting
Display Problem Measure
Continu-
ous lamp
Paper
jam
You have fed in too much paper.
The cutting unit runs in reverse for a few seconds and pushes the
paper back out again.
• If necessary, press the reverse button “R” to remove the stack of paper.
• Take half the stack of paper.
• Feed the paper in portions.
Overload • The motor was overloaded. Let the shredder cool down for approx.
15 – 20 mins. before using it again.
Flashing
light
General
fault
displays
• A fault has occurred while shedding paper.
Pull the paper out of the slot to clear the light barrier.
Shredded
material
container
full
• Empty the shredded material container.
Note:
If you press the reverse button briefl y before removing the container,
part of the material is pulled back into the cutting apparatus.
Container
open
• Insert the shredded material container correctly in the base cabinet.
To Next Page
Loading...
Need help?
General
