12/2014 SECURIO B 22 15
english
7 Cleaning and maintenance
WARNING
Dangerous mains voltage!
Switch off the shredder and pull
out the mains plug.
When cleaning only use a soft cloth and a
mild soap-water solution. However, no water
must enter the equipment.
Oil the cutting unit when
cutting performance de-
creases or the device
becomes noisy, or every
time you empty the waste
container (Cross cut only).
Only use HSM special
lubricating oil for the
cutting unit to do this:
• Spray the special cutting
unit oil through the paper feed along the
entire width of the cutting shafts.
• Let the cutting unit run in the permanent
mode for about 10 seconds without any
paper.
Paper dust and particles are shaken off.
8 Disposal / Recycling
Electrical and electronic old de-
vices contain a variety of valuable
materials, but also hazardous
substances which were required
for function and safety. Incorrect
disposal or handling can be dan-
gerous to your health and the environment.
Never dispose of old devices in the house-
hold waste. Observe the current applicable
regulations and use the collection points for
returning and recycling electric and elec-
tronic devices. Dispose of all the packaging
materials also in an environmentally-respon-
sible way.
To Next Page
Loading...
Need help?
General
