HST HP101 - User Manual

HP101
Fire Alarm Control Panel 4-16 Zones
User & Installation Manual
IMPORTANT
This manual should be left with the panel after installation.
We reserve the right to change product specifications without prior notice.

Summary

1.3 Fire Alarm System Limitations

1.4 Installation Precautions

2. Control Panel Installation

2.1 Important Notice

Critical safety notice regarding qualified personnel, regulatory compliance, and potential life-saving implications of incorrect installation.

2.3 AC Power Connection

Detailed instructions and warnings for connecting the AC power supply to the control panel, including circuit requirements.

2.4 Battery Installation

Guidance on installing backup batteries at the bottom of the enclosure and indicators for battery status.

2.5 Zone Installation

Instructions for wiring conventional input zones, including detector connections and the use of end-of-line (EOL) resistors.

2.12 Inner Door Label (Wiring Diagram)

A detailed wiring diagram found on the inner door, showing terminal connections for zones, outputs, power, and communication.

3. Control Panel Operation

4. LED Indicators

Fault Yellow LED

Explanation of the Fault Yellow LED indicating trouble conditions and their common causes.

5. Fault Finding

Fault LED and sense zone fault LED flashing, buzzer sounding

Identifies faults related to sense zone wiring (open/short circuits, detector removal) and how to check them.

Fault LED and Sounder(NAC) zone fault LED flashing, buzzer sounding

Identifies faults related to Sounder (NAC) zone wiring (open/short circuits) and EOL resistor requirements.

Fault LED flashing and Mains fault LED on, buzzer sounding

Identifies faults related to mains supply issues such as no supply or blown mains fuse.

Fault LED flashing and Battery fault LED on, buzzer sounding

HST HP101 Specifications

General

Brand	HST
Model	HP101
Category	Control Panel
Display Type	LCD
Input Voltage	24VDC
Communication Interface	RS485
Operating Temperature	-10°C to 50°C