5-23 Pre Operation Checks
1. RPM indicator
2. Left turn indicator light
3. Speed indicator
4. Right turn indicator light
5. 2WD / 4WD indicator light
6. Differential Lock indicator light
Speedometer unit functions:
⚫ a speedometer (which shows the speed)
⚫ an odometer (which shows the total distance covered)
⚫ a tripometer (which can be cleared and then show any new distances traveled)
⚫ an RPM indicator (which shows the revolutions per minute of the engine)
⚫ a clock
⚫ an EFI fault code indicator (which shows the fault code for problems with the EFI )
Odometer and trip meter modes
On the display panel there are two large buttons, one located on the left side and one
on the right side. Quickly pressing the button on the left side toggles the display from
the odometer, to the tripometer, and then to the hours meter; then it starts the cycle
over.
The odometer displays the total distance traveled by the TRACTOR. The tripometer
records distances for a specific trip and can record distances from 0 through 999.9
miles.
To reset a trip meter, select it by pressing the
left button, Press left button to switch to small mileage (Trip), press the right button for
a long time to reset. The tripometer can be used to estimate the distance that can be
traveled with a full tank of fuel. This information will enable you to judge the fuel
consumption.
To change the display from miles per hour to kilometers per hour press the right side
button on the display. This will also change the displayed mileage from miles to
kilometers.
Clock time adjustment
Press the left button and hold for three seconds and the clock goes into the hour ‘set’
mode.
1. Press the right button to set the hour.
To Next Page
Loading...