HT60
EN - 14
4.3.7. Temperature measurement
CAUTION
Before attempting any temperature measurement, cut off power supply from
the circuit to be measured and make sure that all capacitors are discharged,
if present.
Fig. 8: Use of the instrument for Temperature measurement
1. Select position °C or °F on the instrument.
2. Insert the provided adapter into input terminals VHz%CAPTemp (polarity +)
and COM (polarity -) (see Fig. 8).
3. Connect the provided K-type wire probe or the optional K-type thermocouple (see §
6.3.2) to the instrument by means of the adapter, respecting the positive and negative
polarity on it. The display shows the value of temperature.
4. The message “O.L.” indicates that the value of temperature exceeds the maximum
measurable value.
5. To use the HOLD function, see § . 4.2
To Next Page
Loading...
