Operation
HTC 400 DS
16 2.0
4.3. Access to grinding tools
Warning!
After grinding, the tools will be very hot. Tip the machine back
and allow it to stand for a short while. Use protective gloves when
removing the tools.
Warning!
When changing tools or making repairs, the power to the machine
must be disconnected.
1. Set the handle to the rear position - see Figure
4-1 on page 15.
2. Tip the machine backwards so that it rests against the
ground.
4.4. Fitting and replacing grinding tools
Warning!
When changing tools or making repairs, the power to the machine
must be disconnected.
Warning!
After grinding, the tools will be very hot. Tip the machine back
and allow it to stand for a short while. Use protective gloves when
removing the tools.
4.4.1. Fitting grinding tools
1. Slide the grinding tool diagonally from above down into
the appropriate guide slot on the tool holder. Then push the
tool fully into the guide slot, see Figure 4-2 on page 17.
To Next Page
Loading...
