HTC 400 DS - Table of Contents

HTC 400 DS
Table of contents
Table of contents
1. Introduction.........................................................1
1.1 General information...................................................... 1
1.2 Responsibility................................................................ 1
1.3 Manual.......................................................................... 1
1.3.1 Safety instructions – Explanation of symbols....... 1
1.4 Transportation............................................................... 2
1.5 On delivery....................................................................2
1.6 Unpacking the machine................................................3
1.7 Machine name plate..................................................... 4
1.8 Handling and storage................................................... 4
1.9 Vibration and noise.......................................................5
1.9.1 Hand and arm vibrations...................................... 5
1.9.2 Sound pressure level............................................5
2. Safety...................................................................6
2.1 General Information...................................................... 6
2.2 Warnings....................................................................... 6
2.3 Notes.............................................................................7
3. Machine description.......................................... 9
3.1 General machine description........................................9
3.2 Description of controls – Control panel...................... 12
4. Operation...........................................................13
4.1 General....................................................................... 13
4.2 Handle settings........................................................... 15
4.3 Access to grinding tools............................................. 16
4.4 Fitting and replacing grinding tools.............................16
4.4.1 Fitting grinding tools........................................... 16
4.4.2 Changing grinding tools......................................17
4.5 Preparations for dry grinding...................................... 18
4.6 Control........................................................................ 19
4.6.1 Starting and stopping the machine.....................19
4.6.2 Emergency stop switch...................................... 19
4.7 Making operation easier............................................. 21