HTC 650 E Classic - Grinding Tool Management

HTC 650 E Classic Operation
3.0 15
4.4 Access to grinding tools
Warning!
Always remove the weights before changing tools, to prevent the machine from
tipping back.
Warning!
During grinding, the tools become very hot. Tip the machine back and allow it
to stand for a short while. Use protective gloves when removing the tools.
Warning!
Disconnect the electrical supply when cleaning, carrying out maintenance,
changing tools or repairing the machine.
1. Set the handle to the rear position - see Figure4-1, page13
2. Removing the weights.
3. Tip the machine backwards carefully so that it rests on the floor.
4.5 Fitting and replacing grinding tools
As the machine is equipped with the patented EZchange tool system, fitting and
replacing grinding tools is quick and easy. The tool system consists of wings on which
diamond grinding tools are fitted without the need for screws.
Warning!
Disconnect the electrical supply when cleaning, carrying out maintenance,
changing tools or repairing the machine.
Warning!
During grinding, the tools become very hot. Tip the machine back and allow it
to stand for a short while. Use protective gloves when removing the tools.