HTC 650 E Classic - Changing Grinding Tools

HTC 650 E Classic Operation
3.0 17
4.5.2 Changing grinding tools
1. Remove the grinding tool by giving it a few light taps with a rubber hammer so the
locking mechanism releases, seeFigure4-5, page17. Then draw the tool up out
of the guide slot.
Figure 4-5. Removing grinding tools
2. Slide the grinding tool diagonally, from above, down into the appropriate guide slot
on the tool holder, seeFigure4-3, page16. Then push the tool fully into the guide
slot.
3. Lock the grinding tool into the tool holder by giving it a few light taps with a rubber
hammer - see Figure4-4, page16.