Operation HTC 650 E Classic
20 3.0
4.8.3 Starting the machine
For a description of the control panel, seeFigure3-3, page11.
1. Make sure the emergency stop switch has not been activated.
2. Insert the cable.
3. Start the dust extractor if dry grinding is to be done.
4. Turn the ON/OFF knob to the right.
5. Start the grinding discs rotation, by turning the REW/FWD knob to the desired
direction of rotation.
6. Set the speed for the grinding discs using the Speed knob.
7. The machine has now started.
4.9 Making operation easier
In order to keep the suction hose for the dust extractor and the power cable out of the
working area and/or path of the machine, the hose and cable can be arranged as shown
in the picture below.
Figure 4-6. Making operation easier
Tip!
By arranging the hose and cable as shown in the picture, you avoid disruptive
stoppages caused by having to re-position the cable and hose.
To Next Page
Loading...
