How to reduce high temperature in the electrical cabinet of my HTC DURATIQ RX6?
To reduce high temperature in the electrical cabinet of your HTC Floor Machine, clean the fans and cooling flange. Ensure the fans are rotating during grinding and for 1 minute after finishing, as well as when needed. Allow the machine to cool down.
Why my HTC DURATIQ RX6 Floor Machine cannot cope?
If your HTC Floor Machine cannot cope, consider these potential causes and solutions: * Too high a load: Reduce the grinding pressure. * If the cause is not listed: If the machine runs at high speed, lower the revs per minute to make the machine stronger. Refer to the meter for available power. * Voltage drop: Check the voltage meter during grinding. * Too sticky a coating on the surface: Run half of the machine on the surface to be cleaned and half on the clean surface to remove residue from the tools. * If the cause is not listed: Check the tools to ensure the correct tools are used, that they are in working order and correctly fitted.
Why does the fuse keep tripping on my HTC DURATIQ RX6 Floor Machine?
A fuse might trip on your HTC Floor Machine due to: * Too high a load or too small fuses: Check the size and inertia of the fuses. * If the cause is not listed: Reduce the machine's load by reducing the grinding pressure, lowering the revs per minute, or changing the tool. Refer to the machine's power meter.
Outlines essential safety rules and responsibilities for machine operators and users.
Information on measured vibration levels and permitted exposure times for operators.
Explanation of the Human-Machine Interface (HMI) controls and their functions.
Details the various indicators and readouts on the machine's information display panel.
Guidance on how to position and adjust the machine's weights for optimal grinding pressure and balance.
How to maneuver and control the machine using the control panel during grinding.
Detailed steps for operating the machine in manual grinding mode.
Explanation of the emergency stop switch's function and proper usage.
Detailed explanation of the radio remote control, receiver, and their operational procedures.
Instructions for charging, operating via radio, and locking wheels.
Comprehensive guide to setting up and using the radio control system for machine operation.
Information on authorized repair services and contacting retailers for servicing.
Troubleshooting steps for when the machine fails to start or experiences power supply problems.
Troubleshooting steps for recurring issues with fuses or earth fault breakers tripping.
Remedies for situations where the machine is not performing optimally or is overloaded.
Explanation of warning (yellow) and error (red) messages displayed on the machine.
Details on red error messages, machine stops, and how to attempt resetting errors.
General| Model | DURATIQ RX6 |
|---|---|
| Category | Floor Machine |
| Power Source | Electric |
| Weight | 240 kg / 529 lbs |
| Frequency | 50 Hz / 60 Hz |
| Working Width | 600 mm |
| Grinding Width | 600 mm |
To Next Page
