32 Getting Started
1.4 Using the Strap Holder
The strap holder at the bottom panel of your device allows you to attach a wrist
strap, neck lanyard, or string accessory.
To attach a strap, lanyard or string accessory to the strap holder
1. Remove the back cover.
2. Insert the loop of the strap, lanyard
or string accessory through the
strap holder hole at the bottom of
the back cover.
3. Pull the loop from the inner side of
the back cover, then attach it over
the strap holder’s T-shaped hook
as shown on the illustration at the
right.
Tip Use a pointed object, such as a
needle, to easily push the loop
into the strap holder hole.
1
2
3
4. Replace the back cover.
To Next Page
Loading...
