5. Make sure the audio cable runs under the band, and not over the top. Check that it isn't
also wedged between the clip and the band.
6. Close the clasp around the band and snap into place.
Attaching the headphone audio cable
After the left and right on-ear headphones have been attached, attach the headphone audio
cable to the headset band.
1. Remove the front pad from the headset band. For details, see Removing the front and back
pads on page 16.
2. On the front section of the band, press the audio cable marker into the slot at the center.
Then press the cable along the groove until flush with the band.
30 Headset and headphones
To Next Page
Loading...
