Removing the batteries from the controller
1. Gently push down on the icon near the top of the battery cover, then slide and lift to
remove it.
2. Pull the tab in the battery compartment to remove the batteries.
3. Replace the battery cover.
Attaching the lanyards to the controllers
Using the lanyards may help prevent the controllers from accidentally being dropped; however,
please do not fling or violently throw the controller as the lanyard may break.
1. Gently push down on the top of the battery cover, then slide and lift to remove it.
2. Insert the lanyard loop on the corresponding hole at the bottom of the controller. Make
sure that the loop is hooked around the post.
3. After replacing the battery cover, slide the lanyard over your wrist, and then slide the lock
to tighten the lanyard comfortably around your wrist.
45 Controllers
To Next Page
Loading...
